Pin connector pads
DOMAS 24 Pack 2x2&2x4 TENS Pads with Pad Holder, for TENS 7000
Fresh pin-tail gel pads in two pad sizes, built to fit lead wires that end in thin metal pins rather than round snap studs.
$9.98
Listed the day this page was put together. The retail listing has the final say.
| Shelf | Pin connector pads |
|---|---|
| Plugs into | TENS 7000 and other 2 mm pin units, DOMAS units |
| Catalog number | B093SNSXHS |
About this one
If your current pads slide off mid-session or leave dried residue behind, the gel layer has run its course. This set brings fresh stick and includes two sizes to match the units we name beside this. Check the lead wire in your drawer before choosing, because these take a slender pin pushed into the pad tail.
The pin socket fit
Look at the tip of your lead wire. If it ends in a small straight metal pin, it pushes directly into the tail socket on these pads. Units with round metal buttons will need snap pads instead.
Thick hydrogel layer
We coat the cloth backing with a solid layer of conductive hydrogel. It grabs smoothly on flat surfaces, holds its tack across multiple uses, and pulls away without leaving a sticky mess behind.
Two rectangular sizes
The pack splits between small squares and broader rectangular pads. Use the smaller ones when working around tighter bends, and switch to the wider pads when you want broader surface coverage under one wire.
The plastic storage tray
After a session, press the pads flat onto the included plastic tray instead of letting them curl in a drawer. Keeping the gel covered stops dust and stray lint from ruining the adhesive surface.
