Pin connector pads
DOMAS Large TENS Pads for Lower-Back Pain Relief
A broad adhesive pad set with split release liners and thin pin sockets that accept standard wire ends from our pulse units and similar gear.
$14.99
Listed the day this page was put together. The retail listing has the final say.
| Shelf | Pin connector pads |
|---|---|
| Plugs into | TENS 7000 and other 2 mm pin units, DOMAS units |
| Catalog number | B0C54Y3WRJ |
About this one
Wide pad shapes tend to curl at the corners if the backing is stiff or the wire tugs from one spot. We cut these broad pieces with curved notches and pair each pad with twin tail sockets. Your wire pins slide straight in, seated flush to keep the whole surface down.
Twin tail sockets
Two pin leads push into the tail of each pad rather than one central post. The pull from your cable spreads across the wide backing instead of lifting a single edge when you shift in a chair.
Center release liner
Large adhesive pads like to fold and grab themselves before you get them laid flat. We split the backing plastic down the middle so you can peel one half, set the first edge, and smooth the rest down.
Notched broad shape
The wide footprint has rounded outside corners and center cutouts that flex over curved areas without bunching up. The gel layer stays continuous right out to the edges so contact remains solid across the whole pad.
Standard pin match
The sockets on the pad tails take the thin pin style lead wires found on our pulse units and the units we name beside this. Check your drawer wire to be sure the end is a pin rather than a snap.
